Siemens SITOP PSU8600, Manual

Page: 366 / 420

Troubleshooting
8.3 Alarm list web server
Power supply system SITOP PSU8600
366
Manual, 09.2018, A5E36758446-5-76
ID Severity Event Help text
39 F Invalid system configuration. System configuration is incorrect. Normal operation of the
system is not possible.
40 MD Stored module configuration cor-
rupt
Stored system configuration is corrupt. Deviations from the
expected response may occur outside normal operation.
41 MR Invalid system configuration. System configuration is different. The system can be oper-
ated.
42 F Stored module configuration cor-
rupt
Stored module configuration is corrupt. The module cannot
start up correctly.
43 MD Stored module configuration cor-
rupt
Stored module configuration is corrupt. Deviating module
behavior may be possible.
44 MR Stored module configuration cor-
rupt
Stored module configuration is corrupt. Module behavior
remains consistent, however.
45 F Hardware failure A hardware failure has occurred. All outputs of the power
supply system have been switched off.
46 F Module failure A hardware failure has occurred. All outputs of the power
supply system have been switched off.
47 N Different firmware version detected Different firmware version detected
48 N Different serial number detected Different serial number detected
49 MR Module with excessive power de-
tected.
A module with excessive power was detected. Normal oper-
ation of the system is possible.
50 MR Unexpected module type detected. Unexpected module type detected.
51 MD Module with reduced power de-
tected.
A module with reduced power was detected. Deviating sys-
tem behavior may be possible.
52 F Incompatible module detected. The module has a module type that is incompatible with the
configuration. The module cannot be commissioned.
53 F Unexpected empty slot detected. Unexpected empty slot detected.
54 F Unknown module found (slot 1). Unknown module found (slot 1).
55 F Unknown module found (slot 2). Unknown module found (slot 2).
56 F Unknown module found (slot 3). Unknown module found (slot 3).
57 F Unknown module found (slot 4). Unknown module found (slot 4).
58 F Unknown module found (slot 5). Unknown module found (slot 5).
59 F Unknown module found (slot 6). Unknown module found (slot 6).
60 F Unknown module found. Unknown module found.
61 N Buffer mode The primary power supply has failed; the power supply
system is being supplied through the buffer component.
62 N Sufficient buffer readiness Sufficient buffer readiness has been achieved; the charge
status of the buffer components in the system has reached
the preset threshold value.
63 MR Buffer readiness disabled No buffering possible because the buffer component has
been disabled.
64 N Parameter out of permissible value
range.
A control command is attempting to set a value outside the
value range that the hardware module can implement. The
value is automatically limited to the minimum or maximum
permitted value for the module.