Engineering and remote access
7.7 Web server
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
273
Activating the web server for the REMOTE operating mode
Proceed as follows if you wish to activate the web server for the REMOTE operating mode of
the SITOP PSU8600:
1.
Navigate in menu "HW Configuration".
2.
Navigate in submenu "General" > "Web server".
3.
In the editor area "General" activate option "Activate web server on this module".
The web server of the SITOP PSU8600 is now activated for access in the MANUAL and
REMOTE operating modes.
Using the web server in the REMOTE operating mode
Proceed as follows if you wish to use the web server in the REMOTE operating mode with
full write authorization:
1.
Set DIP switch "REN" (Remote enable) at the basic unit SITOP PSU8600 to "ON".
The SITOP PSU8600 is in the REMOTE operating mode.
Note
After switching over into the REMOTE operating mode, the SITOP PSU8600 continues to
operate without any changes. However, device parameters can only be changed via
remote access.
2.
Click on "Log out", to log out from the current web service session.
The logon page opens.
3.
Logon again (user name: "admin", password: "admin"), to access the web server in the
REMOTE operating mode.
The start page of SITOP PSU8600 is opened. You can navigate to further menus from
the start page.
Deactivating web server access for the MANUAL operating mode
If you wish to deactivate the web server for access to the SITOP PSU8600 in the MANUAL
operating mode, then proceed as follows:
1.
Set DIP switch "WEN" or "FUNC" at the SITOP PSU8600 basic unit to "OFF".
The web server is deactivated for the MANUAL operating mode.
Note
After deactivating the MANUAL operating mode, then the SITOP PSU8600 can only be
accessed with the web server in the REMOTE operating mode.