Engineering and remote access
7.7 Web server
Power supply system SITOP PSU8600
272
Manual, 09.2018, A5E36758446-5-76
6.
Press "Logon".
Enter the logon information in the following logon page:
Initial values:
–
User name: "admin"
–
Password: "admin"
The start page of SITOP PSU8600 is opened. You can navigate to further menus from
the start page.
7.
Change the password, see Chapter "User administration (Page 291)".
Changing the IP address in the device
Proceed as follows if you wish to change the preset IP address in the device:
1.
Navigate in menu "HW Configuration".
2.
Navigate in submenu "General" > "Communication interface".
3.
Ensure that the editor area "Set IP address" is selected.
4.
Enter the required IP address in the "IP address" field and "Subnet mask". Example of an
entry: 192.168.20.xx.
The new IP address should be located in the same subnet as the PC. If this is not the
case, then the IP address of the PC must be appropriately changed.
5.
Click on the "Download to device" button to load the actual configuration to the device.
Note
The new IP address becomes immediately active after you have loaded it to the device.
The connection to the web server is immediately interrupted.
The SITOP PSU8600 generates a new SSL certificate for web server access. This
operation takes between 30 seconds and up to 2 minutes.
To avoid repeated generation of the SSL certificate, for the web server, use a fixed IP
address even if, in your system, the DHCP automatically assigns IP addresses.
6.
Wait for approximately two minutes until the SSL certificate has been generated.
7.
Open the web browser and enter the new IP address in the address field of the browser.
8.
Press "Logon".
Enter the logon information in the following logon page:
Initial values:
–
User name: "admin"
–
Password: "admin"
The start page of SITOP PSU8600 is opened. You can navigate to further menus from
the start page.
