142
System Manual V2 – MOVITRAC® B
6
Priority of the operating statuses and interrelation between control signals
Project Planning
6.18
Priority of the operating statuses and interrelation between control signals
6.18.1 Priority of operating states
The following illustration shows the priority of operating states:
6.18.2 Interrelation between control signals
The following table shows the interrelation between control signals. "CW/Stop" is
programmed to binary input DIØ1 and cannot be changed. The other control signals are
only in effect if a binary input is programmed to this function
(→
parameter P60_).
Linking control signals:
Controller inhibit
Stop
Enable
Rapid stop
high
low
Priority
/Controller inhibit
Binary input is programmed to
Inverter status
Enable/
Rapid stop
CW/stop (DI01)
CCW/stop
"0"
1)
1) Not relevant when the binary input is on controller inhibit and "/Control inhibit" = "0"
1)
1)
Inhibited
"1"
"0"
2)
2) Not relevant if "Enable/Rapid stop" = "0"
2)
"1"
"1"
"1"
"0"
CW enabled
"1"
"1"
"0"
"1"
CCW enabled
* If a binary input is programmed to this function.
=1
&
&
CW
CCW*
ENABLE*
/CONTROLLER INHIBIT*
Drive control
Summary of Contents for MOVITRAC MC07B0037-2A3-4-00
Page 250: ......
