Completing Card Configuration
79
Server, the Card’s value is used and sent to the Server on the next
connection. This means that changes of this setting from a
command-line are persisted.
The following Card security-related configuration settings are
affected by the
Card Security Level
setting.
Network connection information—netmask, gateway IP
address, Management Server IP address, Management Server
port.
Security settings—DES Key, Card security level, Enable
password.
The Server has authority over these settings except
when the Card Security Level is set to HIGH. Even when the Card
Security Level is HIGH, however, these values are not sent to the
Server if they are changed on the Card.
c.
You set the Enable password during initial Card configuration at
the Appliance. You do not need to type it here unless you are
changing it. If you want to change it, type the same password in
the
Enable Password
and
Confirm Enable Password
boxes.
20.
Click
OK
to save the changes and download them to the Card.
Continue with one of the following:
If you need to install new software on the Card(s), see "Card Software
Installation" on page 79. Perform this procedure only if instructed to do
so by SecureLogix installation or support personnel. Otherwise, see the
next bullet.
Continue with ―Configuring Telco Spans" on page 83.
Since the Appliances are shipped with factory defaults, the latest version of
the Appliance software may not be installed. The ETM System installation
directory contains the latest software available at release. Additional
software updates may be available from the SecureLogix website at
www.support.securelogix.com
. Install the latest software version before
continuing configuration. Appliance software is located at the following
path:
<INSTALL_DIR>\ps\software_repository\package
Copy the latest version to this directory. You can install software on
multiple Cards at once when the Appliances are the same models.
Otherwise, you must install software on individual Cards.
Card Software
Installation
