Install the Appliances
55
2.
Start the terminal emulation application (such as HyperTerminal) on
your terminal. Configure your terminal using the following serial port
settings:
115,200 bps
no parity
8 data bits
no flow control
1 stop bit
3.
Initiate the session (procedure varies by type of emulation application).
By default, during the first two minutes of power-on, the Card is in
Enable mode and does not require a username/password combination
for access. After two minutes or one login session, you must log in with
a valid username/password combination. However, you can modify or
disable this mode. To change the Enable mode timeout, see "Changing
the Enable Mode Timeout" on page 60.
4.
At the
Select an installation USERNAME
prompt, type a
username and press ENTER.
5.
At the
Select an installation PASSWORD
prompt, type a
password and press ENTER. This temporary username and password
are used only for initial Card configuration and remain on the Card
only until communication with the Management Server is established,
at which time they are erased. Permanent user accounts are defined at
the Management Server using the Performance Manager. A password
can be any combination of characters. It must be a minimum of eight
characters in length, and must include at least one change of case and
one digit.
6.
At the
Select an initial ENABLE PASSWORD
prompt, type an
Enable password and press ENTER. The Enable password must contain
at least 8 characters and must follow the Rules for a good, strong
password and include at least one change of case and special character.
The Enable password can be a maximum of 50 characters. The Enable
password allows you to change Card and Span configuration
parameters via the serial port and Telnet. Unlike the temporary
installation name and password, the Enable password you supply
during out-of-box configuration is sent up to the ETM Server and
remains valid unless it is changed via the Performance Manager.
7.
At the
Select Card IP address option
prompt, type
1
to accept the
suggested IPv6 address and prefix; type
2
to specify either an IPv4 or
IPv6 address manually. Press ENTER.
8.
Do one of the following:
If you chose option 1:
At the
Select card IPv6 gateway
prompt, type the IPv6 gateway and then press ENTER. See step 9.
If you chose option 2:
At the
Select card IP address
prompt, type the IPv4 or IPv6 address you want to use for the card,
and then press ENTER.
The AAA 1050
supports only IPv4.
