60
Step 2: Hardware Installation
By default, during the first two minutes of power-on, the Card is in Enable
mode and does not require a username/password combination for access.
After two minutes or one login session, you must login with a valid
username/password combination. However, you can change this default to a
lesser value, including 0 seconds. If the Enable mode timeout is not
changed from the default, you will enter Enable mode on subsequent login
sessions.
To change the Enable mode timeout
At the
ETM(r/w)>
prompt, type:
ENABLE LOGIN <
value
>
where <
value
> is the number of seconds for the timeout. For example,
to always require a logon to access the Card, type:
ENABLE LOGIN 0
Out-of-the-box Card configuration is complete. Continue with
"Configuring the ETM® System" on page 61.
Changing the
Enable Mode
Timeout
