Install the Appliances
49
Install the Appliances
WARNING
To ensure equipment and personnel safety, before you begin
installing the Appliance(s), read the suggestions and warnings
in
ETM
®
System Safety and Regulatory Information
provided
with your Appliances.
Installation of the ETM Appliances consists of the following sequence of
steps:
1.
(
Applies to ETM 2100 and 3200 Appliances only
.) Install the Controller
Card(s) and Digital Trunk Interface(s) in the Appliance chassis.
2.
Mount the Appliance chassis in an equipment rack or on the wall.
3.
Connect the SMDR cable to the Card that is to be the SMDR provider
for the Switch, if SMDR is used.
4.
Connect the power cable and power on the Appliance.
5.
(1050 AAA only)
Connect the telephone line(s) to the modem port(s).
6.
Use a Console session to configure the Card(s) to connect to the
Management Server.
7.
(
Not applicable to VoIP, analog, or SS7 Signaling Links
) Change the
telco Spans' types, if applicable. All of the Spans in the digital ETM
telco Appliances (except the SS7 Signaling Links) are configured for
T1 CAS by default.
8.
Connect the Ethernet cable.
See "Appendix A: Appliance Technical Specifications, Connectors, and
Pinouts" on page 167 for diagrams of each connector on the
ETM Appliances.
