Configuring Telco Spans
105
Endpoint precedence specifies whether the source and destination addresses
should be reported as a URI or a phone number when both are available in
the signaling. Use the following ETM Command per Span to specify
precedence:
ENDPOINT PRECEDENCE pn | url
VoIP Span configuration is complete. Continue with one of the
following:
(
1090 Appliance only
) If you are using just the VoIP Span in a 1090
and want to remove the unused TDM Span from the GUI, see
―Removing an Unused TDM Span in the ETM® 1090 Appliance‖
below.
Continue with Span-type specific configuration for other types of Spans
you are installing:
-
―E1-Specific Span Settings‖ on page 107.
-
―T1-Specific Span Settings‖ on page 109.
-
―PRI-Specific Span Settings‖ on page 112.
-
―SS7 Signaling Link-Specific Span Settings‖ on page 115.
-
More Spans of the same type: ―Importing Span Configuration‖ on
page 118.
If all Span settings have been supplied, continue with ―Installing
Dialing Plans‖ on page 119.
The ETM 1090 Appliance is a hybrid Appliance that provides one VoIP
Span and one TDM digital Span. When the ETM 1090 Appliance connects
to the Management Server, a VoIP Span and a TDM Span both appear in
the Performance Manager in the
Platform Configuration
subtree. If you
are using only the VoIP Span, you can remove the unused TDM Span from
the tree, but first, you must disable communication between the Server and
the TDM Span. In the ETM 1090 Appliance, the TDM Span is Span 1 and
the VoIP Span is Span 2.
To remove a Span
1.
In the
Platform Configuration
subtree, right-click the Span that you
want to remove, and then click
ASCII Management
.
2.
In the
Enter Command
box, type
SERVER COMM OFF 1
Then press ENTER.
Specifying
PN/URI
Precedence
Removing an
Unused TDM
Span in the
ETM
®
1090
Appliance
