Schweitzer Engineering Laboratories SEL-700G Series, Instruction Manual

Page: 69 / 824

2.17
Date Code 20170814 Instruction Manual SEL-700G Relay
Installation
I/O Configuration
Figure 2.4 JMP1 Through JMP4 Locations on 4 AI/4 AO Board
You need to insert three jumpers for a current analog output selection and two
jumpers for a voltage analog output selection. For a current analog output
selection, insert a jumper between pins 1 and 2, pins 5 and 6, and pins 9 and
10. For a voltage analog output selection, insert a jumper between pins 3 and
4, and pins 7 and 8. Figure 2.5 shows JMP4 selected as a current analog
output. The current analog output selection is the default setting for JMP1
through JMP4. Figure 2.6 shows JMP1 selected as a voltage analog output.
Figure 2.5 Current Output Jumpers Figure 2.6 Voltage Output Jumpers
JMP1 JMP2
JMP3
JMP4
9 7 5 3 1
10 8 6 4 2
JMP1–JMP4 Pin
Numbering
NOTE:
There is no jumper between
Pins 5 and 6 for a voltage analog
output selection.
9
5
1
10
6
2
JMP4
JMP4 Selected as Current Output
7
5
3
8
6
4
JMP1
JMP1 Selected as Voltage Output