Schweitzer Engineering Laboratories SEL-700G Series, Instruction Manual

Page: 819 / 824

3
Date Code 20170814 Instruction Manual SEL-700G Relay
SEL-700G Relay Command Summary
SER C or R Clears SER data.
SER D Displays SER delete report, which shows deleted items (use when SER auto-deletion is selected to remove
chatter).
SHO n Displays relay settings for group n (n = 1, 2, or 3). If n is not specified, default is the active settings group.
SHO F Displays front-panel settings.
SHO G Displays global settings.
SHO L n Displays general logic settings for group n (n = 1, 2, or 3). If n is not specified, default is the active settings
group.
SHO M Displays Modbus User Map settings.
SHO P n Displays port settings, where n specifies the port (1, 2, 3, 4, or F); n defaults to the active port if not listed.
SHO R Displays report settings.
STA Displays relay self-test status.
STA S Displays SEL
OGIC
usage status report.
SUM Displays an event summary.
SUM R or C Resets event summary buffer.
SYN n Displays generator synchronism-check report.
TAR Displays default target row or the most recently viewed target row.
TAR n Displays target row n.
TAR n k Displays target row n. Repeat display of row n for repeat count k.
TAR name Displays the target row with target name in the row.
TAR name k Displays the target row with target name in the row. Repeat display of this row for repeat count k.
TAR R Resets any latched targets and the most recently viewed target row.
TIM Views time.
TIM hh:mm:ss Sets time by entering TIM followed by hours, minutes, and seconds, as shown (24-hour clock).
TRI Triggers an event report data capture.
Access Level 2 Commands
AST Auto Start—starts generator automatic synchronizing control.
ASP Auto Stop—stops generator automatic synchronizing control.
ANA c p t Tests analog output channel where c is the channel name or number, p is a percentage of full scale or either
letter “R” or “r” indicates ramp mode, and t is the duration of the test in decimal minutes.
BRE n R Resets breaker data for breaker n, where n = X or Y.
BRE n W Preloads breaker data for breaker n, where n = X or Y.
CAL Enters Access Level C. If the main board access jumper is not in place, the relay prompts for the entry of
the Access Level C password. Access Level C is reserved for SEL use only.
CLO n Closes circuit breaker n, where n = X or Y.
CON RBnn k Selects a remote bit to set, clear, or pulse where nn is a number from 01 to 32, representing RB01 through
RB32. k is S, C, or P for Set, Clear, or Pulse.
COP m n Copies relay and logic settings from Group m to Group n.
DTO Downloads Volts/Hz user curve from SEL-5806 Curve Designer Software.
FIL WRITE filename Transfers settings file filename from the PC to the relay.
GEN R Resets generator operating statistics report data.
Serial Port Command Command Description