Schweitzer Engineering Laboratories SEL-700G Series, Instruction Manual, Page: 824 / 824

4
SEL-700G Relay Instruction Manual Date Code 20170814
SEL-700G Relay Command Summary
GRO n Modifies active group setting.
L_D Loads new firmware.
LOO Enables loopback testing of M
IRRORED
B
ITS
channels.
LOO A Enables loopback on M
IRRORED
B
ITS
Channel A for the next 5 minutes.
LOO B Enables loopback on M
IRRORED
B
ITS
Channel B for the next 5 minutes.
MET WE Preload energy meter registers.
OPE n Opens circuit breaker n , where n = X or Y.
PAS 1 Changes Access Level 1 password.
PAS 2 Changes Access Level 2 password.
PUL n t Pulses Output Contact n ( n = OUT101…) for t (1 to 30, default is 1) seconds.
SET n Modifies relay settings for group n ( n = 1, 2, or 3). If n is not specified, default is the active settings group.
SET name For all SET commands, jumps ahead to a specific setting by entering the setting name, for example,
50P1P.
SET F Modifies front-panel settings.
SET G Modifies global settings.
SET L n Modifies SEL
OGIC
variable and timer settings for group n ( n = 1, 2, or 3). If n is not specified, default is
the active settings group.
SET M Modifies Modbus User Map settings.
SET P n Modifies port n settings ( n = 1, 2, 3, 4, or F; if not specified, the default is the active port).
SET R Modifies report settings.
SET … TERSE For all SET commands, TERSE disables the automatic SHO command after the settings entry.
STA R or C Clears self-test status and restart relay.
SYN R Resets the breaker close time average and breaker close operations counter in the synchronism-check
report data.
VEC D Displays standard vector diagnostics report (useful to the factory in troubleshooting).
VEC E Displays extended vector diagnostics report (useful to the factory in troubleshooting).
Access Level C Command
PAS C Changes Access Level 2 password.
Serial Port Command Command Description