Rizzoli RV 100, Instructions Manual

Page: 71 / 132

ENGLISH
69
The standard installation of the wood fired
cooker considers that the comburent air is
taken from the room where the cooker is
installed through the air intake of the cook-
er located in the plinth. In this case, in the
room must be always ensured the recycle
of fresh air, in particular if the room is small
and window and door frames are hermetic.
The correct flow of air in the room must be
ensured also in presence of other combus-
tion based devices, aspiring hoods, chimneys
and vent-holes. The air intake in the room
must have a minimum surface of 80 cm
2 .
On demand, Rizzoli can give specific valves
which can allow the automatic opening of
the air intake only when it is necessary for
the correct working of the wood fired cook-
er, in order to warrant a maximum depres-
sion of 3 Pa in the place of installation.
RV range wood fired cookers can also be
connected so that the comburent air comes
directly from outside. In this way, for the
wood fired cooker it is not necessary an-
other air intake in the room of installation.
To make this it is necessary to prepare a con-
duct connected directly with the external
2.10 AIR OUTLETS
The connection with the chimney must be
always well fixed and sealed, it must not
have narrowing and must not decrease the
usable section of the chimney (see picture
10). If near the cooker there is inflammable material or high temperatures sensible, the
connection must be isolated and the safety
distances must be strictly observed.
Picture 9 - Flue outlet on the side. Fixed connector for the flue outlet on the side.
Picture 10 - Examples of correct and incorrect connection of the chimney
NO NO NO YES