Rizzoli RV 100, Instructions Manual

Page: 70 / 132

ENGLISH
68
Picture 7 - Cooker with oven multiflue, predisposition of the correct flue outlet
RV with oven
2.9 CORRECT CONJUNCTION TO THE CHIMNEY
If the conduct of the chimney starts from a
lower floor than the connection point of the
cooker, it may be necessary to close the con-
duct under the connection pipe with fire-
proof materials.
If you have the chimney behind or up, you
have to use the connector with bayonet cou- pling. This must be inserted and turned so
that it can remain blocked. This connector
has a tolerance of about 1 cm to make the
installation easier. The tolerance is available
according to a single direction which de-
pends on the orientation of the connector
(see picture 8).
If you have a lateral chimney in correspond-
ence of a side, the connector is sliding. To
install it correctly, it is necessary to remove
the cooking plate. Now, the connector must
be completely inserted inside the wood
fired cooker or the chimney, keeping the
fixing buttonhole on the same side of the
cooker. Then, you can place the wood fired
cooker, extract correctly the connector so that it connect the cooker with the chimney.
Finally, bend the buttonhole and block the
parts with the screw-lock (see picture 9).
Picture 8 - Tolerance for flue outlet on the top and back. The tolerance depends on the orientation of the connector.
+/-
10 mm
Y
X
+/-
10 mm