Raven RS Lite, Calibration And Operation Manual

Page: 99 / 125

016-4010-001 Rev. J 93
SLINGSHOT
Interference on channels will vary by location and other radio communication in the area. If too much interference
is present, the system may encounter frequent communication or link errors. If this occurs, change the radio
channel for each radio in the system to find a channel with less interference.
Radio Tx (Transmit) Power. The radio signal power to transmit to other radios in the autonomous system. The
value must be between 10 and 30.
Lower values typically offer better results for near proximity (e.g. syncing with the combine, smaller fields, etc.).
Higher values may be required to transmit across larger fields or through tree lines, but may cause more
interference when machines are operating close together.
Non-Controlling Combine Present. Use the drop down list to set the number of non-controlling combines
present during field operations.
NOTE: The value set for the number of non-controlling combines present must be set on the Radio Link tab
on each machine in the OMNiDRIVE™ system (e.g. the tractor, the controlling combine, and each
non-controlling combine).
Radio IP Address. If the connection point is set to Manual, the Radio IP Address field may be used to enter the IP
address desired for the RS1.
NOTE: A reboot is required each time the IP address is changed. This field is only displayed when set to
Manual.