R&S AFQ100A
AFQ Commands - Signal Generation
1401.3084.32 6.27
E-3
Baseband Block - Trigger and Input Settings
The Trigger and Input system contains the commands for configuration of the trigger settings.
Command Parameter Default
unit
Note
[SOURce:]INPut:CONTrol:IMPedance G50,
G1K
-
[SOURce:]INPut:CONTrol:THReshold 0...
2
V
V
[SOURce:]INPut:TRIGger:SEGMent:SLOPe POSitive,
NEGative
-
[SOURce:]INPut:TRIGger:SLOPe POSitive,
NEGative
-
[SOURce:]TRIGger:EXECute -
No
query
[SOURce:]TRIGger:MODE
CONTinuous | SINGle | REPeatN
[SOURce:]TRIGger:RCOunt 1...100
[SOURce:]TRIGger:RENable
ON | OFF
[SOURce:]TRIGger:RMODe?
Query
only
[SOURce:]TRIGger:SEGment:DELay 0...10
sec
S
[SOURce:]TRIGger:SEGMent:EXECute
No
query
[SOURce:]TRIGger:SEGMent:INHibit 0...10
sec
S
[SOURce:]TRIGger:SEGMent:MODE
CONTinuous | SEAMless | SINGle | REPeatN
[SOURce:]TRIGger:SEGMent:RCOunt 1...100
[SOURce:]TRIGger:SEGMent:SOURce
MANual | EXTernal | BUS | AUTO
[SOURce:]TRIGger:SOURce
MANual | EXTernal | BUS | AUTO
[SOURce:]TRIGger[:EXTernal]:DELay 0...10
sec
S
[SOURce:]TRIGger[:EXTernal]:INHibit 0...10
sec
S
[SOURce:]WSEGment? -
Query
only
[SOURce:]WSEGment:NEXT -
[SOURce:]WSEGment:NEXT:Mode
AINCrement | FPARallel | FSERial
[SOURce:]INPut:CONTrol:IMPedance
G50 | G1K
Clock source
external
only!
Sets the impedance for the three inputs CLOCK IN, TRIG, and NEXT (segment trigger). The lower
value is recommended for high clock frequencies. The meanings of the abbreviations G50 and G1k
are 0.05 k
i
and 1.00 k
i
, respectively.
Example:
INP:CONT:IMP G50
'sets the input impedance to 50
i
.
*RST value
Resolution
Options
SCPI
G1K -
Device-specific
