trunk
Usage
trunk [-a <action>] [-i <trunk id>]
trunk -a add -s “<list of settings>”
Summary
The trunk command is used to display and modify port trunk settings for the iSCSI host interface.
Options
-a <action>
Specifies the action to perform.
add
Create a new trunk.
list
Displays trunk information.
mod
Modify an existing trunk setting.
del
Delete a trunk.
-i [<trunk id>]
Port trunk identifier. (1 - 8).
-s [“<option>=<value>”]
Used to specify which trunk settings to change.
ctrlid=
Controller ID of Port
masterport=
Master port of the Trunk. Range: Port ID
slaveport=
List of ports aggregated in this trunk, excluding the master port
Range:
Port ID.
trunktype=
trunk type
balance_xor
Transmits based on XOR formula. (Source MAC address is XOR’d
with destination MAC address) modula slave count. This selects the same
slave for each destination MAC address and provides load balancing and
fault tolerance.
lacp
This mode is known as Dynamic Link Aggregation mode. It creates
aggregation groups that share the same speed and duplex settings. This
mode requires a switch that supports IEEE 802.3ad Dynamic link.
221
Promise
Technology
Managing with CLI