Handling precautions
Ÿ
Do not open the ESD (electro-static discharge) bag
containing the drive until required.
Ÿ
Do not apply pressure on the drive during handling
or installation.
Ÿ
Always handle the drive with care to prevent dam-
age from shock, vibration, or electrostatic discharge
Ÿ
Handle the drive carefully by the edges. Do not
touch any exposed printed circuit board.
Ÿ
Do not cover the breather hole! Covering the
breather hole may result in loss of
data.
Quick installation procedure
1.
Save the packaging materials including the ESD
bag in the event that the drive must be returned.
2.
Backup all data before beginning installation.
3.
Record the serial number and part number of your
IBM Deskstar drive for future reference.
4.
Turn off the computer and remove the system
cover.
5.
Discharge the static electricity from the package
and from your body. With one hand touch an
unpainted metal surface on your computer chassis,
then touch the ESD bag with the other hand for at
least 2 seconds.
6.
Remove the drive from the ESD bag.
7.
Unplug the computer.
8.
Set the jumpers. Refer to the diagram below.
•
If the drive is the only drive on the cable, set the
jumpers at A-B and G-H for 16 logical head
architecture. This is the Master setting.
•
If the drive is the "Slave" drive on a two-drive
cable, set the jumpers at A-B and C-D for 16
logical head architecture. This is the Slave
setting.
The shipping default setting is Master 16 logical head
architecture.
Jumper block
I
A
G
E
C
H
F
D
B
9. Attach the IDE cable.
•
If you have a 40 pin, 40 conductor cable, attach
the system connector of the
cable to the IDE port
on the
motherboard or controller card. The pin 1
side of an IDE cable is marked with a stripe. The
connectors are keyed to insert one way only.
•
If you have a 40 pin, 80 conductor cable, attach
the drive to the appropriate color coded con-
nector. ATA/66 cables are color coded for the
Master, Slave, and system connectors. The
Master connector is black, the Slave connector is
gray, and the system connector is blue.
10. Attach the power supply cable to the hard disk
drive. Match the connector bevels.
IBM storage products
Page 1
IBM Hard Disk Drive Technical Support Center version 4.0
Quick installation guide
Deskstar 25GP & 22GXP
ATA/IDE
DJNA-352500 DJNA-352030
DJNA-351520 DJNA-351010
DJNA-372200 DJNA-371800
DJNA-371350 DJNA-370910
Models:
