Polaroid 539957-020 Rev. A, User Manual

Page: 84 / 184

74 Card Design and Setup
Normally, smart card setup is provided by a value-added reseller or service
provider. Information about the smart card module installed and the type of
cards to use can be requested from your service provider or value-added reseller.
Requirements
The following items are required when personalizing smart cards:
•
A direct local connection
between the printer and the PC.
•
Smart card reader in the printer.
•
A smart card cable for the smart
card port used. The illustration
shows the location of the smart
card connection on the printer.
•
Card application that is customized to work with the printer and the smart
card application (using the driver SDK or ID software application with a
smart card application manager)
•
Smart cards that work with the reader in the printer
Smart Card Codes on the Printer Label
The configuration label includes codes to identify the type and model of smart
card module installed in the printer. The following table lists the codes used on
the configuration label.
The S1 value on the configuration label indicates that the printer was ordered
from the factory with the basic smart card components installed. An integrator
must install a contactless reader supplied by others.
If the S2 value is included in the configuration code, the printer has shipped from
the factory with the basic components of an S1, plus the SCM Dual (Contact/
Contactless) Interface installed.
Code on Label Type of Smart Card Module
S1 Integrator
S2 SCM Dual Interface Reader