FL SWITCH GHS CLI
2-4
PHOENIX CONTACT
8039_en_01
speed all
This command sets the speed and duplex setting for all interfaces.
show port
This command displays port information.
Mode
Interface Config
Acceptable Values Definition
100h
100BASE-T half duplex
100f
100BASE-T full duplex
10h
10BASE-T half duplex
10f
10BASE-T full duplex
Format
speed all
{<100 | 10> <half-duplex | full-duplex>}
Mode
Global Config
Acceptable Values Definition
100h
100BASE-T half duplex
100f
100BASE-T full duplex
10h
10BASE-T half duplex
10f
10BASE-T full duplex
Format
show port
{<slot/port> | all}
Mode
Privileged EXEC
Term
Definition
Interface
Valid slot and port number separated by a forward slash.
Type
If not blank, this field indicates that this port is a special type of port. The possible values are:
•
Mirror
- this port is a monitoring port. For more information, see
“Port Mirroring” on page 65
.
•
PC Mbr
- this port is a member of a port-channel (LAG).
•
Probe
- this port is a probe port.
Admin Mode
The Port control administration state. The port must be enabled in order for it to be allowed into the
network. - May be enabled or disabled. The factory default is enabled.
Physical Mode
The desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex mode
and speed is set from the auto-negotiation process. Note that the maximum capability of the port (full
duplex -100M) is advertised. Otherwise, this object determines the port's duplex mode and
transmission rate. The factory default is Auto.
Physical Status
The port speed and duplex mode.
Link Status
The Link is up or down.
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx