FL SWITCH GHS CLI
4-2
PHOENIX CONTACT
8039_en_01
The
<trafficclass>
values can range from 0-6, although the actual number of available
traffic classes depends on the platform.
no classofservice ip-dscp-mapping
This command maps each IP DSCP value to its default internal traffic class value.
classofservice trust
This command sets the class of service trust mode of an interface. You can set the mode to
trust one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings. You can also
set the interface mode to untrusted. If you configure an interface to use Dot1p, the mode does
not appear in the output of the
show running config
command because Dot1p is the
default.
no classofservice trust
This command sets the interface mode to the default value.
Format
classofservice ip-dscp-mapping
<ipdscp> <trafficclass>
Mode
Global Config
Format
no classofservice ip-dscp-mapping
Mode
Global Config
Note:
The
classofservice trust dot1p
command will not be supported in future releases of the software because
Dot1p is the default value. Use the
no classofservice trust
command to set the mode to the default value.
Default
dot1p
Format
classofservice trust
{dot1p | ip-dscp | ip-precedence | untrusted}
Modes
•
Global Config
•
Interface Config
Format
no classofservice trust
Modes
•
Global Config
•
Interface Config
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx