FL SWITCH GHS CLI
6-4
PHOENIX CONTACT
8039_en_01
Example:
The following shows example CLI display output for the network port.
(admin) #show network
IP Address..................................... 10.250.3.1
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.250.3.3
IPv6 Administrative Mode....................... Enabled
IPv6 Address/Length is ........................
FE80::210:18FF:FE82:337/64
IPv6 Address/Length is ........................ 3099::1/64
IPv6 Address/Length is ........................
3099::210:18FF:FE82:337/64
IPv6 Default Router is ........................
FE80::204:76FF:FE73:423A
Burned In MAC Address.......................... 00:10:18:82:03:37
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Web Mode....................................... Enable
Java Mode...................................... Enable
show serviceport
This command displays service port configuration information.
IPv6 Default
Router
The IPv6 default router address.
Burned In MAC
Address
The burned in MAC address used for in-band connectivity.
Locally
Administered MAC
Address
If desired, a locally administered MAC address can be configured for in-band connectivity. To take
effect, 'MAC Address Type' must be set to 'Locally Administered'. Enter the address as twelve
hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit
0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. The MAC address used by this bridge
when it must be referred to in a unique fashion. It is recommended that this be the numerically smallest
MAC address of all ports that belong to this bridge. However it is only required to be unique. When
concatenated with dot1dStpPriority a unique BridgeIdentifier is formed which is used in the Spanning
Tree Protocol.
MAC Address
Type
The MAC address which should be used for in-band connectivity. The choices are the burned in or the
Locally Administered address. The factory default is to use the burned in MAC address.
Network
Configuration
Protocol Current
The network protocol being used. The options are bootp | dhcp | none.
Java Mode
Specifies if the switch should allow access to the Java applet in the header frame. Enabled means the
applet can be viewed. The factory default is enabled. In FL SWITCH GHS Firmware 4.4.4 and later
versions, use the
show ip http
command to view this field.
Web Mode
Specifies if the switch should allow access to the Web Interface. The factory default is enabled. In FL
SWITCH GHS Firmware 4.4.4 and later versions, use the
show ip http
command to view this field.
Term
Definition
Format
show serviceport
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx