Phoenix Contact FL SWITCH GHS 12G/8, User Manual, Page: 225 / 242

RADIUS Commands
8039_en_01 PHOENIX CONTACT
6-41
no radius server attribute 4
Use this command to reset the NAS-IP address for the radius server.
radius server host
This command is used to configure the RADIUS authentication and accounting server. If you
use the
<auth>
parameter, the command configures the IP address or hostname to use to
connect to a RADIUS authentication server. You can configure up to 3 servers per RADIUS
client. If the maximum number of configured servers is reached, the command fails until you
remove one of the servers by issuing the “no” form of the command. If you use the optional
<port>
parameter, the command configures the UDP port number to use when connecting
to the configured RADIUS server. The
<port>
number range is 1 - 65535, with 1812 being
the default value.
If you use the
<acct>
token, the command configures the IP address or hostname to use for
the RADIUS accounting server. You can only configure one accounting server. If an
accounting server is currently configured, use the “no” form of the command to remove it from
the configuration. The IP address or hostname you specify must match that of a previously
configured accounting server. If you use the optional
<port>
parameter, the command
configures the UDP port to use when connecting to the RADIUS accounting server. If a
<port>
is already configured for the accounting server, the new
<port>
replaces the
previously configured
<port>
. The
<port>
must be a value in the range 1 - 65535, with
1813 being the default.
no radius server host
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured RADIUS
authentication server is removed from the configuration. Similarly, if the 'acct' token is used,
Term Definition
ipaddr A valid IP address.
Format
no radius server attribute 4
Mode Global Config
Note: To re-configure a RADIUS authentication server to use the default UDP <port> , set the <port> parameter to
1812.
Note: To re-configure a RADIUS accounting server to use the default UDP <port> , set the <port> parameter to
1813.
Format
radius server host {auth | acct} <ipaddr|hostname> [<port>]
Mode Global Config
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx