User Account Commands
8039_en_01
PHOENIX CONTACT
6-21
U
SER
A
CCOUNT
C
OMMANDS
This section describes the commands you use to add, manage, and delete system users. FL
SWITCH GHS Firmware software has two default users: admin and guest. The admin user
can view and configure system settings, and the guest user can view settings.
users name
This command adds a new user account, if space permits. The account
<username>
can be
up to eight characters in length. You can use alphanumeric characters as well as the dash (‘-
’) and underscore (‘_’). You can define up to six user names.
no users name
This command removes a user account.
users name
<username>
unlock
Use this command to unlock a locked user account. Only a user with read/write access can
re-activate a locked user account.
users passwd
Use this command to change a password. Passwords are a maximum of 64 alphanumeric
characters. If a user is authorized for authentication or encryption is enabled, the password
length must be at least eight alphanumeric characters. The password is case sensitive. When
you change a password, a prompt asks for the old password. If there is no password, press
Note:
You cannot delete the admin user. There is only one user allowed with read/write privileges. You can
configure up to five read-only users on the system.
Note:
The
<username>
is not case sensitive when you add and delete users, and when the user logs in. However,
when you use the
<username>
to set the user password, authentication, or encryption, you must enter the
<username>
in the same case you used when you added the user. To see the case of the
<username>
, enter the
show users
command.
Format
users name
<username>
Mode
Global Config
Format
no users name
<username>
Mode
Global Config
Note:
You cannot delete the “admin” user account.
Format
users name
<username>
unlock
Mode
Global Config
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx