Command Modes
8039_en_01
PHOENIX CONTACT
1-5
the system. The management address can be associated with the network port (front-
panel switch ports), a routine interface (port or VLAN) and the Service port.
•
WLAN Switching (4.4.2 and later)
•
Stacking
Not all modules are available for all platforms or software releases.
C
OMMAND
M
ODES
The CLI groups commands into modes according to the command function. Each of the
command modes supports specific FL SWITCH GHS Firmware software commands. The
commands in one mode are not available until you switch to that particular mode, with the
exception of the User EXEC mode commands. You can execute the User EXEC mode
commands in the Privileged EXEC mode.
The command prompt changes in each command mode to help you identify the current
mode.
Table 5
describes the command modes and the prompts visible in that mode.
Note:
The command modes available on your switch depend on the software modules that are installed. For
example, a switch that does not support BGPv4 does not have the Router BGPv4 Command Mode.
Table 5:
CLI Command Modes
Command Mode
Prompt
Mode Description
User EXEC
Switch>
Contains a limited set of commands to view basic
system information.
Privileged EXEC
Switch#
Allows you to issue any
EXEC
command, enter the
VLAN mode, or enter the Global Configuration mode.
Global Config
Switch (Config)#
Groups general setup commands and permits you to
make modifications to the running configuration.
VLAN Config
Switch (Vlan)#
Groups all the VLAN commands.
Interface Config
Switch (Interface <slot/port>)#
Switch (Interface Loopback <id>)#
Switch (Interface Tunnel <id>)#
Manages the operation of an interface and provides
access to the router interface configuration
commands.
Use this mode to set up a physical port for a specific
logical connection operation.
Line Config
Switch (line)#
Contains commands to configure outbound telnet
settings and console interface settings.
Policy Map
Config
Switch (Config-policy-map)#
Contains the QoS Policy-Map configuration
commands.
Policy Class
Config
Switch (Config-policy-class-map)#
Consists of class creation, deletion, and matching
commands. The class match commands specify
Layer 2, Layer 3, and general match criteria.
Class Map Config
Switch (Config-class-map)#
Contains the QoS class map configuration commands
for IPv4.
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx