FL SWITCH GHS CLI
6-2
PHOENIX CONTACT
8039_en_01
network parms
This command sets the IP address, subnet mask and gateway of the device. The IP address
and the gateway must be on the same subnet.
network protocol
This command specifies the network configuration protocol to be used. If you modify this
value, change is effective immediately. If you use the
bootp
parameter, the switch
periodically sends requests to a BootP server until a response is received. If you use the
dhcp
parameter, the switch periodically sends requests to a DHCP server until a response is
received. If you use the
none
parameter, you must configure the network information for the
switch manually.
network mac-address
This command sets locally administered MAC addresses. The following rules apply:
•
Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally
administered (b'0') or locally administered (b'1').
•
Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an
individual address (b'0') or a group address (b'1').
•
The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
network mac-type
This command specifies whether the switch uses the burned in MAC address or the locally-
administered MAC address.
Format
network parms
<ipaddr> <netmask> [<gateway>]
Mode
Privileged EXEC
Default
none
Format
network protocol
{none | bootp | dhcp}
Mode
Privileged EXEC
Format
network mac-address
<macaddr>
Mode
Privileged EXEC
Default
burnedin
Format
network mac-type
{local | burnedin}
Mode
Privileged EXEC
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx