Phoenix Contact FL SWITCH GHS 12G/8, User Manual, Page: 174 / 242

FL SWITCH GHS CLI
5-20
PHOENIX CONTACT 8039_en_01
Use the
traceroute
command to discover the routes that packets actually take when
traveling to their destination through the network on a hop-by-hop basis. Traceroute
continues to provide a synchronous response when initiated from the CLI.
Using the options described below, you can specify the initial and maximum time-to-live
(TTL) in probe packets, the maximum number of failures before termination, the number of
probes sent for each TTL, and the size of each probe.
Example:
The following are examples of the CLI command.
Example: traceroute Success:
(FL SWITCH GHS Firmware Routing) # traceroute 10.240.10.115 initTtl
1 maxTtl 4 maxFail 0 interval 1 count 3 port 33434 size 43
Traceroute to 10.240.10.115 ,4 hops max 43 byte packets:
1 10.240.4.1 708 msec 41 msec 11 msec
2 10.240.10.115 0 msec 0 msec 0 msec
Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6
Default
•
count: 3 probes
•
interval: 3 seconds
•
size: 0 bytes
•
port: 33434
•
maxTtl: 30 hops
•
maxFail: 5 probes
•
initTtl: 1 hop
•
Format
traceroute < ipaddr|hostname > [ initTtl < initTtl >] [ maxTtl < maxTtl >]
[ maxFail < maxFail >] [ interval < interval >] [ count < count >]
[ port < port >] [ size < size >]
Mode Privileged EXEC
Parameter Description
ipaddr|hostname
The
ipaddr
value should be a valid IP address. The
hostname value should be a valid
hostname.
initTtl Use
initTtl
to specify the initial time-to-live (TTL), the maximum number of router hops between the
local and remote system. Range is 0 to 255.
maxTtl Use
maxTtle
to specify the maximum TTL. Range is 1 to 255.
maxFail Use
maxFail
to terminate the traceroute after failing to receive a response for this number of
consecutive probes. Range is 0 to 255.
interval Use
interval
to specify the time between probes, in seconds. Range is 1 to 60 seconds.
count Use the optional
count
parameter to specify the number of probes to send for each TTL value. Range
is 1 to 10 probes.
port Use the optional
port
parameter to specify destination UDP port of the probe. This should be an
unused port on the remote destination system. Range is 1 to 65535.
size Use the optional size parameter to specify the size, in bytes, of the payload of the Echo Requests sent.
Range is 0 to 65507 bytes.
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx