RADIUS Commands
8039_en_01
PHOENIX CONTACT
6-43
radius server primary
This command is used to configure the primary RADIUS authentication server for this
RADIUS client. The primary server handles RADIUS requests. The remaining configured
servers are only used if the primary server cannot be reached. You can configure up to three
servers on each client. Only one of these servers can be configured as the primary. If a
primary server is already configured prior to this command being executed, the server
specified by the IP address or hostname specified used in this command will become the new
primary server. The IP address or hostname must match that of a previously configured
RADIUS authentication server.
radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted when
no response is received from the RADIUS server. The retries value is an integer in the range
of 1 to 15.
no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, to the
default value.
radius server timeout
This command sets the timeout value (in seconds) after which a request must be
retransmitted to the RADIUS server if no response is received. The timeout value is an integer
in the range of 1 to 30.
no radius server timeout
This command sets the timeout value to the default value.
Format
radius server primary
<ipaddr|hostname>
Mode
Global Config
Default
4
Format
radius server retransmit
<retries>
Mode
Global Config
Format
no radius server retransmit
Mode
Global Config
Default
5
Format
radius server timeout
<seconds>
Mode
Global Config
Format
no radius server timeout
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-14161-Phoenix-Contact-2700271-FL-SWITCH-GHS-4G/12-Modular-Ethernet-Switch.aspx