Setting
up Compax3
C3I20T11 / C3I32T11
230
192-120103 N13 C3I20T11 / C3I32T11 December 2010
Controller optimization Advanced
„Controller optimization Advanced“
Observer technology
Observer time constant (Obj. 2120.1) >=125µs
(the higher the value, the slower the observer)
Select speed jerk response in the setup window /
tab “parameter”, select the size of the jerk and
specify the jerk.
Respect the setpoint speed and the actual speed
Smooth, stable behavior?
yes
no
Main diagram
Move over the entire positioning range, verify the
settings and correct if necessary.
Store settings with WF!
Stabilize controller with the aid of:
•
Decrease stiffness (Obj. 2100.2)
•
or/also reduce observer time constant (Obj. 2120.1)
•
or/also reduce control signal filter (Obj. 2120.1)
•
or/also modify attenuation (Obj. 2100.3)
•
Vary filter of observed disturbance (Obj. 2120.5) or switch off
disburbance (reduce stiffness before!)
1.)
Vary “observer time constant” (Obj. 2120.1)
increase “stiffness” (Obj. 2100.2) until the optimum is
reached
2.)
In systems with
high friction
, reduce “attenuation”
(Obj. 2100.3) and increase “stiffness” (Obj. 2100.2)
until the optimum is reached.
3.)
In the event of
optimization to speed constancy
,
increase “attenuation” (Obj. 2100.3) and reduce
“stiffness” as far as necessary (Obj. 2100.2) until the
optimum is reached.
4.)
Disturbance (Obj. 2120.7) in connection with the
“filter of observed disturbance” (Obj. 2120.5)
may cause further improvements.
