Panasonic Electric Works Nordic AB
MEW01351
Rev: -
Planning Instructions Fire alarm system EBL512 G3, V1.1.x
5
16.22
Test of routing equipment ________________________ 110
16.23
Calibration of supervised outputs __________________ 110
16.24
Service signal _________________________________ 110
16.25
Fault signal (fault condition) ______________________ 111
16.26
Alarm texts ___________________________________ 111
16.26.1
Creating the alarm texts via WinG3 ____________ 111
16.26.2
Downloading alarm texts to the DU:s 1728 / 1735 /
1736 and ext. FBP:s 1826 / 1828 ________________________ 113
16.27
Real time clock (RTC) __________________________ 113
16.27.1
Daylight saving time ________________________ 114
16.28
Loss of main power source _______________________ 114
16.29
Evacuate _____________________________________ 114
16.30
WinG3 menu Tools _____________________________ 115
17
Special New Zealand functions ______________ 117
17.1
Alarm devices ___________________________________ 117
17.1.1
Silence alarm devices (inside switch) _____________ 117
17.1.2
New Zealand FB Silence switch (outside switch) ____ 117
17.2
Battery faults ____________________________________ 119
17.2.1
FAULT: Battery _____________________________ 119
17.2.2
FAULT: Low battery capacity __________________ 119
17.3
Watchdog reset __________________________________ 119
17.4
Routing equipment isolate (disable) __________________ 119
17.5
Acknowledged alarm _____________________________ 119
18
Cyber sensor functions _____________________ 121
18.1
Pulse up – down counter ___________________________ 122
18.1.1
Pulse up – down counter for smoke ______________ 122
18.1.2
Pulse up – down counter for temperature __________ 122
18.1.3
Pulse up – down counter for smoke & temperature __ 122
18.2
Fire judgement __________________________________ 122
18.3
Alarm threshold levels ____________________________ 123
18.4
Learning function / Learning conditions _______________ 123
18.4.1
Learning conditions ___________________________ 123
18.5
Alarm delay time _________________________________ 125
18.6
Analog data output _______________________________ 126
18.7
Sensitivity compensation __________________________ 126
18.8
Self diagnosis of internal devices ____________________ 127
18.9
Address setting check _____________________________ 127
19
Control unit properties ____________________ 128
19.1
Control unit properties dialog box ___________________ 128
19.1.1
General Information __________________________ 128
19.1.2
Peripherals __________________________________ 128
19.1.3
Misc. ______________________________________ 128
19.2
WinG3 Control unit pop-up menu ___________________ 129
19.2.1
Reset alarm counter ___________________________ 129
19.2.2
Software version _____________________________ 129
