75
6-2 Terminal Block Errors
6-2-1 Trigger Signals (Input Signals) are Not Received.
The cables are not correctly wired.
The signal line is disconnected.
The Z300 is not in RUN mode.
6-2-2 Signals cannot be Output Externally.
The trigger signal has not been input.
The cables are not correctly wired.
The signal line is disconnected.
The Z300 is not in RUN mode.
6-3 RS-232C Communication Errors
6-3-1 No Communications are Possible.
The cables are not correctly wired.
The Z300's communications specifications do not match those of the external
device.
The Z300 is not in RUN mode.
6-3-2 The Unit Operates Well Initially, But After a While There is No
Response from the Z300.
The reception buffer on the external device (e.g., personal computer) is full.
Check that settings allow the data to be properly received.
Terminal Block Errors
Section 6-2
Summary of Contents for Z300 V3 - SETUP
