Omron Z300 V3 - SETUP, Setup Manual, Page: 30 / 98

29
,
If the distance between the front of the Sensor and the workpiece is the
measurement range, these indicators turn ON or OFF according to the distance.
If the workpiece is outside the measurement range or if the light density is insuf-
ficient, both indicators will flash.
These indicators also act as laser beam warning indicators.
- Immediately after the power supply is turned ON, one or both of these indica-
tors will light or flash.
- For 15 to 25 seconds after the power supply is turned ON, both indicators will
be OFF indicating that the laser beam is OFF.
- When the laser beam turns ON, one of these indicators will light or flash.
- When the laser beam turns OFF, both indicators will turn OFF.
Connects to the ground wire.
Connects to the power supply.
, Connects to external devices such as a PLC.
Connects to the monitor.
Connects to a console.
Connects to the sensor.
Connected when using analog output.
Set when using the Z300 in Non-visual Mode.
Refer to page 55.
Connects to external devices such as a personal computer or PLC.
,
,
Turn ON according to the light density at the Sensor.
If LDOFF is input via the terminal block or RS-232C, or if the Sensor is not con-
nected, all of the indicators flash.
- BRIGHT indicator···Turns ON when the light density is too high.
- DARK indicator ···Turns ON when the light density is insufficient.
- STAB indicator ···Turns ON when the light density is suitable.
Distance to measurement center
Measurement range lower limit
Outside measurement range
NEAR indicator
FAR indicator
Lit
Flashing
Not lit
Z300-S2T
Z300-S10
Z300-S5T
Z300-S60
20
100
50
600
19.9
98
49.5
565
19
80
45
250
20.1
102
50.5
635
21
120
55
950
(Unit: mm)
Outside measurement range
Measurement range upper limit
Component Names and Functions Section 2-1