Omron Z300 V3 - SETUP, Setup Manual, Page: 33 / 98

32
2-2-2 System Configuration for Non-visual Mode
The Z300 can be used without a monitor but with a Linear Sensor Controller
connected. In this case, the Z300's menus cannot be used. The way in which the
Z300's analog outputs are used is set at the Linear Sensor Controller.
The mode for this type of operation (without being able to see menus and wave-
forms) is called "Non-visual Mode." To perform operation in Non-visual Mode,
the DIP switch on the Controller must be set to NON VISUAL.
Refer to page 55.
Notice
Turn OFF the power supply before changing the DIP switch settings.
CHECK
When Using the Z300-S60
Use with a cable extension length of less than 3 m in Non-visual Mode.
CHECK
Only 1 Sensor can be connected. Connect it to SENSOR 0.
Notice
Always turn OFF the power supply before connecting or disconnecting cables.
The peripheral device may be damaged if connected or disconnected with the
power supply turned ON.
Power Supply
Recommended model:
OMRON S82K-05024
(See page 36)
Linear Sensor Controller (See page 44)
K3TS (Linear Sensor Digital Panel Meter)
K3AS (Linear Sensor Controller)
K3TJ (Scaling Mater)
K3NX (Digital Panel Meter)
CQM1-LSE (Linear Sensor Interface Unit)
∗
Sensor (See page 48)
Z300-S2T (2-m cable)
Z300-S5T (2-m cable)
Z300-S10 (2-m cable)
Z300-S60 (0.5-m cable)
∗
Sensor Extension Cable
Z309-SC1R
(1.5 m, 3 m, 8 m, 13 m, or 18 m)
Specify the required cable
length when ordering.
8 9.
0 12
0
12.345
67.891
∗
Components marked with
an asterisk are specially
designed for the Z300.
Other products cannot be used.
System Configuration Section 2-2