30
2-2 System Configuration
2-2-1 System Configuration for Visual Mode
The Z300 is provided with menus that allow easy setting of measurement condi-
tions to suit the application. Perform settings on the Console using the menu
items displayed on the monitor. Waveform measurement results can also be dis-
played on the monitor.
The mode used for this type of operation is called "Visual Mode." If the DIP
switch on the Controller is set to VISUAL, the Z300 goes into Visual Mode when
the power supply is turned ON. The DIP switch is factory-set to VISUAL.
CHECK
- Up to 2 Sensors can be connected.
When performing measurement with 2 Sensors at the same time, use Sen-
sors of the same model. It is possible to connect different Sensors but it will
not be possible to perform measurement using both at the same time.
For details on using different models, refer to page 146 in the Operation
Manual.
Power Supply Recommended model: OMRON
S82K-05024(See page 36)
∗
Sensor (See page 50)
Z300-S2T (2-m cable)
Z300-S5T (2-m cable)
Z300-S10 (2-m cable)
Z300-S60 (0.5-m cable)
∗
Sensor Extension Cable
Z309-SC1R (1.5m, 3 m, 8 m, 13 m, or 18 m)
Specify the required cable length
when ordering.
Z300-VC10EV3/Z300-VC15EV3 Controller
∗
Console
Z300-KP(2-m cable)
∗
Components marked with
an asterisk are specially
designed for the Z300.
Other products cannot be used.
ESC
TRIG
SHIFT
ENT
CONSOLE
System Configuration
Section 2-2
Summary of Contents for Z300 V3 - SETUP
