27
,
If the distance between the front of the Sensor and the workpiece is the
measurement range, these indicators turn ON or OFF according to the distance.
If the workpiece is outside the measurement range or if the light density is insuf-
ficient, both indicators will flash.
These indicators also act as laser beam warning indicators.
- Immediately after the power supply is turned ON, one or both of these indica-
tors will light or flash.
- For 15 to 25 seconds after the power supply is turned ON, both indicators will
be OFF indicating that the laser beam is OFF.
- When the laser beam turns ON, one of these indicators will light or flash.
- When the laser beam turns OFF, both indicators will turn OFF.
Emits laser beam.
Receives laser beam.
Light used when displaying surrounding images.
Captures surrounding images.
Used for switching between display of surrounding images and measure-
ment. To display surrounding images, loosen the screws of the beam cover
lever and move the lever to the left. To perform measurement, move the lever to
the right. Tighten the lever screws with a flat-bladed screwdriver to a torque in
the range 0.15 to 0.3 N
•
m (1.5 to 3 kgf
•
cm).
CHECK
When Using the Z300-S2T
- When performing measurement with the beam cover removed, attach the
monitor cap provided with the Sensor in the way shown below.
- When displaying surrounding images, be sure to attach the beam cover. Sur-
rounding images cannot be displayed correctly without the beam cover
attached.
Distance to measurement center
Measurement range lower limit
Outside measurement range
NEAR indicator
FAR indicator
Lit
Flashing
Not lit
Z300-S2T
Z300-S10
Z300-S5T
Z300-S60
20
100
50
600
19.9
98
49.5
565
19
80
45
250
20.1
102
50.5
635
21
120
55
950
(Unit: mm)
Outside measurement range
Measurement range upper limit
Display of surrounding images
Lever
Measurement
Lever
Two, M2
×
4
Lever screws: M2
×
5
Monitor cap
(provided as an accessory)
Beam Cover Attached
Beam Cover Removed
Component Names and Functions
Section 2-1
Summary of Contents for Z300 V3 - SETUP
