30
Introduction
Section 4-1
4-1
Introduction
There are two ways to teach the reading conditions: Using a DIP
switch and using a Console. Monitor is required to teach using a Con-
sole.
Note
Teaching is used to automatically set parameters based on the
results of reading an actual code.
Using the DIP Switch (Refer to page 31.)
Using the Console (Refer to page 35.)
24VDC
PWR
RUN
ERR
RS-232C
SCANNER
MONITOR
CONSOLE
2D CODE READER
V530-C300
1
2
3
4
5
6
O
N
TRIG
1
2
3
4
5
6
O
N
The DIP switch on the controller
is set according to the code
being read and a code is read by
pressing the Trigger Switch on
the Scanner. If reading is
successful, the settings are
automatically registered and
saved in flash memory.
24VDC
PWR
RUN
ERR
RS-232C
SCANNER
MONITOR
CONSOLE
2D CODE READER
V530-C300
TRIG
Settings are made using a
Console and Monitor and a code
is read by pressing the Trigger
Switch on the Scanner. If
reading is successful, the
settings are automatically
registered and saved in flash
memory.
