24
Terminal Block Specifications
Section 3-6
Program Example
100 CLOSE #1
110 OPEN ”COM:E73NN” AS #1 (OPEN communications port)
120 PRINT #1,”@GL”+CHR(&H0D) (Send single reading command)
130 INPUT #1,RESDATA$ (Load data; footer code:CR)
140 PRINT ”READ DATA=”;RESDATA$ (Display reading data)
150 GOTO 120 (Repeat)
160 END
3-6
Terminal Block Specifications
3-6-1
Terminal Name
3-6-2
Crimp Terminals and Cables
The terminal block uses M3 terminal screws. Use appropriate crimp
terminals for M3 screws, as shown below. Tighten the screws to a
torque of between 0.5 and 0.6 N•m. After wiring, check to make sure
that the wiring is correct.
24VDC
PWR
RUN
ERR
RS-232C
SCANNER
MONITOR
CONSOLE
2D CODE READER
V530-C300
TRIG
TRIG Terminal (Level Trigger)
Reading will be repeated while
the trigger is ON until a reading is
successfully made. If reading
was not completed successfully
by the time the trigger goes OFF,
a NG result is output.
Terminal
Maker
Model No.
Wire size
J.S.T. Mfg. Co., Ltd.
V1.25-N3A
1.31 to
1.65 mm
2
(AWG16
to
AWG15)
J.S.T. Mfg. Co., Ltd.
V1.25-MS3
Forked
6.2 mm max.
Round
6.2 mm max.
