Omron CJ1W-FLN22, Operation Manual, Page: 135 / 277

109
Command/Response Reference Section 7-5
4. FA Link Startup Method
This bit provides details about the communications settings (automatic for
manual log in) when PLC power is turned ON.
5. Message Procedure Check
This bit provides details about the message procedure settings (checked
or not checked).
6. Broadcast Format
This bit provides details about the broadcast format settings.
7. Data Sending Order (Sequential/Reverse Direction)
8. Baud Rate
This bit is used to set the baud rate.
Ethernet Address
(Response) The Ethernet address of the FL-net Unit is returned.
Note The Ethernet address is marked on the label on the side of the FL-
net Unit.
Bit Description
1
0 Automatic Log In
Communications are enabled automatically by turning ON PLC power.
1 Manual Log In
Communications are not enabled by turning ON PLC power. With this setting,
communications are enabled instead by turning ON the FA Link Connection
Start Bit after the PLC is turned ON. (Refer to
Unit Control Bits (CPU Unit to
FL-net Unit) on page 52.)
Bit Description
1
0 Checked
Select only when sending messages between OMRON FL-net (Ver. 2.00)
Units.
1 Not checked
Select when connected to another manufacturer’s FL-net (Ver. 2.00) node.
Bit Description
1
0 ***.***.255
1 255.255.255.255
Bit Description
1
0 Sequential order
Same order as earlier FL-net Unit (CS1W-FLN02 and CS1W-FLN12).
1 Reverse order
Swaps the upper/lower byte order of word data before sending data link data.
Bit Description
1
0 10 Mbps fixed
Communications are performed at 10 Mbps.
1 Automatic detection
The baud rate between hubs is automatically detected. Communications are
performed at 100 Mbps depending on the hub.