Omron CJ1W-FLN22, Operation Manual, Page: 65 / 277

39
Creating an I/O Table Section 3-8
1,2,3... 1. Lay the twisted-pair cable.
2. Connect the cable to the hub. Be sure to press in the cable until it locks into
place.
Request cable installation from a qualified professional.
3. Connect the cable to the connector on the Ethernet Unit. Be sure to press
in the cable until it locks into place.
3-8 Creating an I/O Table
After the hardware settings and connections have been completed, turn ON
the power supply to the PLC and create an I/O table.
3-8-1 I/O Table Overview
An I/O table is used to identify Units connected to the PLC and to allocate I/O
to them. If any change is made to the Unit configuration of a CS-series PLC,
an I/O table must be created to register the Units to the CPU Unit.
3-8-2 Connecting Programming Devices to the PLC
To create the I/O table, connect a Programming Device (such as a Program-
ming Console or CX-Programmer) to the PLC.
Applicable Programming
Devices The following Programming Devices can be used with CS-series PLCs.
Programming Console
CX-Programmer and CX-Integrator
The operations are explained here using a Programming Console. For details
regarding the CX-Programmer and the CX-Integrator, refer to the
CX-Pro-
grammer User’s Manual and the CX-Integrator.
FL-net Unit
RJ45 Modular Connector
Example: CS1W-FLN22
Model number Key Sheet (required) Recommended cable (required)
C200H-PRO27-E CS1W-KS001-E CS1W-CN224 (cable length: 2.0 m)
CS1W-CN624 (cable length: 6.0 m)
CQM1-PRO01-E CS1W-CN114 (cable length: 0.1 m)