Omron CJ1W-FLN22, Operation Manual, Page: 198 / 277

Operating Procedures Section 11-2
172
11-2-3 Network Settings
This section explains how to connect the PLC to a computer on which the FL-
net Unit Support Software is installed. These settings are not required if the
CX-FLnet is launched from the I/O Table Component of the CX-Programmer.
Change the communications settings in the following cases.
• When the CX-FLnet is launched from the I/O Table Component without
inheriting network settings.
• When the CX-FLnet is started from the Windows Start Menu.
• When the FL-net target node is changed (i.e., when the network address,
node address, or unit number is changed).
View Toolbar Switches the toolbar display.
Status bar Switches the status bar display.
Setting To PLC Writes to the setup data of the specified Unit.
From PLC Reads the contents of the setup data of the specified
Unit to the computer.
Compare with
PLC Compares system settings on the computer with the
PLC.
Network setting Makes network settings to communicate with the PLC.
Status Datalink Status Shows the FL-net network data link status.
Error Status Shows the FL-net Unit error status.
Communication
cycle time Shows the communications cycle time of the FL-net net-
work.
Message
sequential status Shows the message sequence status.
Error log Shows the FL-net Unit error log.
Node status Shows the node status in the FL-net network.
Network status Shows the FL-net network status.
Option Extension setting Changes the order of link data bytes.
Switch display Switches the display between decimal and hexadecimal.
Help Index Shows the help files.
Version Shows the CX-FLnet version.
Menu Command Contents