Omron CJ1W-FLN22, Operation Manual, Page: 58 / 277

Hardware Setup Section 3-4
32
Be sure to read and understand all of the following information for each setting
method before setting the IP addresses. For details on FL-net IP addresses,
refer to
FL-net IP Address under Appendix C Network System Definitions .
Note 1. After changing IP addresses or other settings with any of these setting
methods, restart the FL-net Unit.
2. If the IP address of an earlier FL-net Unit (CS1W-FLN02 and CS1W-
FLN12) was set using the rotary switch on the rear of the Unit, reset the IP
address using the CX-FLnet or FL-net Unit Support Software with either of
the above two methods.
Note If a subnet mask is to be set, use the Support Software to set it in the CPU
Bus Unit Setup Area. For details, refer to
SECTION 11 CX-FLnet Support
Software Operations .
IP address setting
method
Node number setting
method
Details
192.168.250 + node
number Rotary switches on front of
Unit (Node Number Switches) This is the default FL-net net-
work address. The node num-
ber is set using the rotary
switches on the front of the
Unit.
Setup area Fourth octet of IP address
(rightmost eight bits of the IP
address) The IP address can be set
when writing the Setup data
using the CX-FLnet or FL-net
Unit Support Software. The
CX-FLnet or FL-net Unit Sup-
port Software is required to
change the IP addresses.