Omron CJ1W-FLN22, Operation Manual, Page: 71 / 277

45
System Setup Section 3-10
3-10 System Setup
The settings for the FL-net Unit’s basic and special functions are made in the
CPU Bus Unit System Setup. These settings, and the situations in which the
settings must be made, are shown in the following table. For details on how to
make the settings, refer to
4-2 CPU Bus Unit System Setup .
3-10-1 When Settings are Required
3-10-2 Using the CX-FLnet or FL-net Unit Support Software
The settings for the CPU Bus Unit System Setup are made using an CX-
FLnet or FL-net Unit Support Software connected to the PLC. The settings
cannot be made using a Programming Console or a CX-Programmer. The
CX-FLnet and FL-net Unit Support Software can be used only for OMRON
FL-net Units.
3-10-3 CPU Bus Unit System Setup Defaults
The following table shows the items in the CPU Bus Unit System Setup, and
their default settings.
Settings When settings are required Page
FA Link mapping table method When the number of nodes assigned to the table exceeds 96. 50
FA Link startup method When using a ladder program to control communications participation
after turning on the power. 50
Confirm message protocol When executing message communications with an FL-net node by
another manufacturer. 50
Broadcast type When changing the broadcast address for any reason. 50
IP address set method When making settings, for any reason, outside of the range of the
default IP address setting method. 50
Sub-net mask When changing the sub-net mask for any reason. 50
Baud rate When changing the baud rate to 100 Mbps. 50
Local node setup When using the Data Link function. 50
Other node setup When using the Data Link function. 50
Minimum allowable frame interval When using a baud rate of 100 Mbps. 181
Item Default
FA Link mapping table method PLC built-in method
FA Link startup method Automatic participation method
Confirm message protocol Confirm
Broadcast type ***.***.***.255
IP address set method 192.168.250.node number
Sub-net mask 255.255.255.0
Baud rate 10 Mbps
Local node setup None
Other node setup None