Omron CJ1W-FLN22, Operation Manual, Page: 119 / 277

93
Overview of FINS Communications Section 7-1
• Units and Boards that support FINS commands return responses auto-
matically, so there is no need for a program at the receiving end.
• The FINS communications service is mainly used between OMRON CPU
Bus Units, CPU Units, and Support Boards for FA Computers. By cor-
rectly setting information such as headers, however, it can also be used
from ordinary Ethernet communications devices.
The FINS communications service can be used from a PLC with either of the
following three instructions:
• SEND(090)/RECV(098)
SEND(090) and RECV(098) are used to send and receive data (area read-
ing and writing).
• CMND(490)
CMND(490) is used to send FINS commands. The particular FINS com-
mands that are supported vary depending of the type of Unit or Board. For
details on FINS commands addressed to FL-net Units, refer to
7-5 Com-
mand/Response Reference . For details regarding FINS commands ad-
dressed to CS/CJ-series CPU Units, refer to the CS/CJ-series
Programmable Controllers Communications Commands Reference Man-
ual
(W342).
The following table shows how the FINS communications service is used by
the communications source and destination.
Local node to remote node SEND(090)/RECV(098) CMND(490) (FINS commands)
PLC to PLC
•
When the PLC executes SEND(090) or
RECV(098), a program is not required for
receiving a response.
•
When the PLC receives a SEND(090) or
RECV(098) instruction, a program is not
required for processing the instruction.
CPU Unit CPU Unit
User program
PLC PLC
•
When the PLC executes CMND(490), a
program is not required for receiving a re-
sponse.
•
When the PLC receives a CMND(490) in-
struction, a program is not required for
processing the instruction.
FL-net Unit
CPU Unit
CPU Unit
When addressed to CPU Unit
User program
PLC PLC