Omron CJ1W-FLN22, Operation Manual, Page: 247 / 277

221
Appendix F
FL-net Unit Support Software Ver. 1.6
FL-net Unit Support Software Overview
The FL-net Unit Support Software is used to make settings for OMRON FL-net Units mounted to Programma-
ble Controllers (PLCs). The FL-net Unit Support Software is installed on a computer running Windows 7 (32-bit
or 64-bit edition), Vista (32-bit or 64-bit edition), or XP (32-bit edition). This computer is connected to a PLC to
which an FL-net Unit is mounted.
Note (1) The FL-net Unit Support Software is designed especially for OMRON FL-net Units.
(2) For information on node settings for FL-net devices from other companies, contact the particular
companies.
(3) The Window operating system is not provided with the Support Software and must be purchased
separately.
Operating Environment
Note (1) Make sure the user has Administrator authority when installing the FL-net Unit Support Software in
a computer running Windows.
(2) Use the FL-net Unit Support Software Ver. 1.60 or later to set the CS1W-FLN22 and CJ1W-FLN22.
Earlier versions of the FL-net Unit Support Software cannot be used to make the following settings.
• Setting baud rate
• Switching upper/lower byte order of data link data
(3) If the FL-net Unit Support Software Ver. 1.51 or earlier is used to set the CS1W-FLN22 or CJ1W-
FLN22, the baud rate will be fixed at 10 Mbps and the data link data upper/lower byte order will be
set to sequential order (the same settings as for CS1W-FLN02 and CS1W-FLN12).
FL-net (Ethernet-based control network)
Panel
computer
CNC RC
PLC
PLC
Computers with
FL-net Support
Software installed.
PLC
Item Conditions
Operating systems Microsoft Windows 7 (32-bit or 64-bit edition)
Microsoft Windows Vista (32-bit or 64-bit edition)
Microsoft Windows XP (32-bit edition)
Hard disk 1 Mbyte or more of free space
Floppy disk drives 1 or more
Display Resolution: 1,024 x 768 pixels min.
Other CPU and memory
requirements Must meet at least the recommended standards for the
operating system.