Omron CJ1W-FLN22, Operation Manual, Page: 189 / 277

163
Inspections Section 10-6
3. Turn OFF the power to the PLC, remove the CS1W-FLN12, and install the
CS1W-FLN22.
4. Turn ON the power to the PLC and check that the RUN indicator on the
CS1W-FLN22 is lit.
5. Write the data that was read using the CX-FLnet or FL-net Unit Support
Software. Select
System setting and Unit area setting , and then click the
Write Button in each of the dialog boxes to write the settings.
6. Restart the CS1W-FLN22 or cycle the PLC power to enable the new set-
tings. Make sure that the RUN indicator on the CS1W-FLN22 is lit.
Changing the IP Address Setting Method
The IP address setting method must be changed to either the default setting
(
192.168.250 + node No. ) or Setup area if the IP address for the CS1W-
FLN12 was set using the rotary switch on the rear of the Unit. Use the follow-
ing procedure to change the IP address setting method.
1,2,3... 1. From the CX-FLnet or FL-net Unit Support Software, read the settings from
the CS1W-FLN12.
Check whether the IP address setting method is set to
Unit rear rotary SW
+ node No. or Unit rear rotary SW .
2. Turn OFF the power to the PLC, remove the CS1W-FLN12, and confirm
the IP address of the corresponding node from the settings for the IP ad-
dress setting rotary switch on the rear of the Unit and the node address
setting switch on the front of the Unit.