Olivetti DP, Technical Information Manual

Page: 105 / 180

Quick Step (OS/2 Warp Server V 4.0)
Chapter 7: OS/2 Network Setup
❖
7-5
Troubleshooting 1 Check cables/drops. Are the LEDs active?
2 Print Settings. Check Enabled=ON,
IPADDRESS=dhcp/bootp/static (make sure the IP Address
resolution is set properly. Use DHCP if your network uses a DHCP
server to assign IP addresses. Use RARP/BOOTP if your network
uses BOOTP to assign IP addresses, and use STATIC if you wish to
enter the IP address via the control panel).
3 Printer Properties - Using LPD Output Port. WIN-OS2 using
LPRMON.
4 Watch LPRPORTD Screen - Is there Activity? In printer input light
processing?
5 It may take a few prints before initial quality responds. Print 10-20
pages first.
6 Refer to the DP System Administrator Guide for additional
information.