NXP Semiconductors MC9S12VRP64, Owner Reference Manual

Page: 206 / 555

S12S Debug Module (S12DBGV2)
MC9S12VRP Family Reference Manual Rev. 1.3
206 NXP Semiconductors
6.3.2.7.2 Debug State Control Register 2 (DBGSCR2)
Read: If COMRV[1:0] = 01
Write: If COMRV[1:0] = 01 and DBG is not armed.
This register is visible at 0x0027 only with COMRV[1:0] = 01. The state control register 2 selects the
targeted next state whilst in State2. The matches refer to the match channels of the comparator match
control logic as depicted in
Figure 6-1 and described in Section 6.3.2.8.1, “Debug Comparator Control
Register (DBGXCTL) . Comparators must be enabled by setting the comparator enable bit in the associated
DBGXCTL control register.
The priorities described in Table 6-36 dictate that in the case of simultaneous matches, a match leading to
final state has priority followed by the match on the lower channel number (0,1,2).
Address: 0x0027
7 6 5 4 3 2 1 0
R 0 0 0 0
SC3 SC2 SC1 SC0
W
Reset 0 0 0 0 0 0 0 0
= Unimplemented or Reserved
Figure 6-10. Debug State Control Register 2 (DBGSCR2)
Table 6-17. DBGSCR2 Field Descriptions
Field Description
3–0
SC[3:0]
These bits select the targeted next state whilst in State2, based upon the match event.
Table 6-18. State2 —Sequencer Next State Selection
SC[3:0] Description (Unspecified matches have no effect)
0000 Match0 to State1....... Match2 to State3.
0001 Match1 to State3
0010 Match2 to State3
0011 Match1 to State3....... Match0 Final State
0100 Match1 to State1....... Match2 to State3.
0101 Match2 to Final State
0110 Match2 to State1..... Match0 to Final State
0111 Either Match0 or Match1 to Final State
1000 Reserved
1001 Reserved
1010 Reserved
1011 Reserved
1100 Either Match0 or Match1 to Final State........Match2 to State3
1101 Reserved
1110 Reserved
1111 Either Match0 or Match1 to Final State........Match2 to State1