NXP Semiconductors MC9S12VRP64, Owner Reference Manual

Page: 449 / 555

64 KByte Flash Module (S12FTMRG64K4KV2)
MC9S12VRP Family Reference Manual Rev. 1.3
NXP Semiconductors 449
All bits in the FSEC register are readable but not writable.
During the reset sequence, the FSEC register is loaded with the contents of the Flash security byte in the
Flash configuration field at global address 0x3_FF0F located in P-Flash memory (see
Table 18-4 ) as
indicated by reset condition F in Figure 18-6 . If a double bit fault is detected while reading the P-Flash
phrase containing the Flash security byte during the reset sequence, all bits in the FSEC register will be set
to leave the Flash module in a secured state with backdoor key access disabled.
7 6 5 4 3 2 1 0
R KEYEN[1:0] RNV[5:2] SEC[1:0]
W
Reset F
1
1
Loaded from Flash configuration field during reset sequence.
F
1
F
1
F
1
F
1
F
1
F
1
F
1
= Unimplemented or Reserved
Figure 18-6. Flash Security Register (FSEC)
Table 18-9. FSEC Field Descriptions
Field Description
7–6
KEYEN[1:0]
Backdoor Key Security Enable Bits — The KEYEN[1:0] bits define the enabling of backdoor key access to the
Flash module as shown in Table 18-10 .
5–2
RNV[5:2]
Reserved Nonvolatile Bits — The RNV bits should remain in the erased state for future enhancements.
1–0
SEC[1:0]
Flash Security Bits — The SEC[1:0] bits define the security state of the MCU as shown in Table 18-11 . If the
Flash module is unsecured using backdoor key access, the SEC bits are forced to 10.
Table 18-10. Flash KEYEN States
KEYEN[1:0] Status of Backdoor Key Access
00 DISABLED
01 DISABLED
1
1
Preferred KEYEN state to disable backdoor key access.
10 ENABLED
11 DISABLED
Table 18-11. Flash Security States
SEC[1:0] Status of Security
00 SECURED
01 SECURED
1
1
Preferred SEC state to set MCU to secured state.
10 UNSECURED
11 SECURED