NXP Semiconductors MC9S12VRP64, Owner Reference Manual

Page: 205 / 555

S12S Debug Module (S12DBGV2)
MC9S12VRP Family Reference Manual Rev. 1.3
NXP Semiconductors 205
6.3.2.7.1 Debug State Control Register 1 (DBGSCR1)
Read: If COMRV[1:0] = 00
Write: If COMRV[1:0] = 00 and DBG is not armed.
This register is visible at 0x0027 only with COMRV[1:0] = 00. The state control register 1 selects the
targeted next state whilst in State1. The matches refer to the match channels of the comparator match
control logic as depicted in
Figure 6-1 and described in Section 6.3.2.8.1, “Debug Comparator Control
Register (DBGXCTL) . Comparators must be enabled by setting the comparator enable bit in the associated
DBGXCTL control register.
The priorities described in Table 6-36 dictate that in the case of simultaneous matches, a match leading to
final state has priority followed by the match on the lower channel number (0,1,2). Thus with
SC[3:0]=1101 a simultaneous match0/match1 transitions to final state.
Address: 0x0027
7 6 5 4 3 2 1 0
R 0 0 0 0
SC3 SC2 SC1 SC0
W
Reset 0 0 0 0 0 0 0 0
= Unimplemented or Reserved
Figure 6-9. Debug State Control Register 1 (DBGSCR1)
Table 6-15. DBGSCR1 Field Descriptions
Field Description
3–0
SC[3:0]
These bits select the targeted next state whilst in State1, based upon the match event.
Table 6-16. State1 Sequencer Next State Selection
SC[3:0] Description (Unspecified matches have no effect)
0000 Any match to Final State
0001 Match1 to State3
0010 Match2 to State2
0011 Match1 to State2
0100 Match0 to State2....... Match1 to State3
0101 Match1 to State3.........Match0 to Final State
0110 Match0 to State2....... Match2 to State3
0111 Either Match0 or Match1 to State2
1000 Reserved
1001 Match0 to State3
1010 Reserved
1011 Reserved
1100 Reserved
1101 Either Match0 or Match2 to Final State........Match1 to State2
1110 Reserved
1111 Reserved