Control System
31
Service Manual – SC1500
Programming Options
The SC1500 graphic display has two “layers” of hidden menus that allow you to view and change the various
programmable machine configurations, system settings and parameters. The top “layer” is the main menu
from which you can navigate to the 20 submenus. The second “layer” is the submenus that display the
programmable options. These submenus are the screens on which you can change the configurations and
settings.
Main Menu Access
1
Turn the key switch to the Off position. (If the optional on-board battery charger
is installed, it must be unplugged from the AC power).
2
Press and hold in the Solution Flow Adjustment Switch and Extra Pressure
Switch simultaneously.
3
While holding both switches, turn the key switch to the On position.
4
Continue to hold the switches until the display shows “Programming Options”.
5
Release both switches.
6
Press the Forward (up) or Reverse (down) Drive Switches to scroll through the links in the
main menu.
7
Press the Burst of Power Switch to enter a submenu.
8
Within a submenu, press the forward/reverse switches to scroll through the options.
9
Press the Scrub switch to save and exit the submenu.
The main menu contains the following links to the
corresponding programming option submenus:
Service Note:
Not all menu entries listed will be functional,
depending on the machine configuration.
Service Note:
The A1 Control Board will automatically display
the main menu upon machine power-up if no scrub
deck has been selected and saved in the
DECK TYPE
submenu. This will occur when a new Control
Board is installed into a machine, or the
RESTORE
DEFAULTS
has been performed. The purpose of this
is to prompt the Operator to select the appropriate
deck type before using the Control Board in the
machine. Once the deck type has been selected, the
controller will no longer automatically display the
main menu at machine power-up.
PROGRAM OPTIONS
1. DECK TYPE
1. DECK TYPE
2. LOW VOLTAGE CUTOUT
3. BATTERY CHARGER
4. BURST OF POWER
5. DETERGENT OPTION
6. DETERGENT RATE BIAS
7. OPEN FAULT DETECT
8. DISPLAY REV LEVEL
9. LOCKOUT BRUSH
10. LOCKOUT SOLUTION
11. BACKUP ALARM VOL
12. FWD ALARM VOL
13. HORN VOL
14. RESTORE DEFAULTS
15. FAULT RECALL
16. SERVICE TEST MODE
17. XTRA INFO ON DISPLAY
18. FROZEN PARAMETERS
19. PANEL TEST
20. SAVE SCRUB SETTINGS
